Battery
DSC-PG9985 Water Sensor Battery Replacement
Replace the Battery - PowerG Wireless Water Sensor Insert a flat-edged screwdriver into the slot and push upward to remove the cover. Remove the screw and separate the cover from the base. Remove the old battery. Important: disposal of used batteries ...
DSC-PG9905 Temperature Sensor Battery Replacement
DSC-PG9914 Motion Sensor Battery Replacement
DSC - Panel Battery Replacement-NO POWER DOWN
Note: Please always have your system disarmed before doing this. 1) Find your security panel. (This is usually in the mechanical room or in a place discussed at the time of install). 2) After finding the security panel, we will need to open it and ...
DSC Power Series 9047 - Panel Battery Replacement
Locate AC power and disconnect from power socket; Using a flat-head screwdriver, pry open the keypad by inserting the screwdriver into the two slots found on the bottom-front of your keypad (there may be a retention screw on the underside); ...
DSC Power Series - Key Fob Battery Change
To change the batteries on your wireless key fob, you will need a small flat head screw driver. Use the end of the screw driver to open the cover Once the cover is off, use the screw driver to remove the circuit board. Once the board has been ...
DSC - Power G - Changing Door/Window Contact Batteries
To change the batteries on your Power G door contact, use a small flat head screw driver insert into the side slats (gently twist to open) Use the screw driver to pop the battery out of place The device takes CR2032 batteries which can be purchased ...
DSC - Power G Sensors - Replacement Battery Guide
Below is a chart of the various sensors used with specific DSC & Qolsys systems (predominantly DSC Neo and Qolsys IQ2+ series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of ...
DSC Power Series Sensors - Replacement Battery Guide
Below is a chart of the various sensors used with DSC systems (predominantly Power and Neo series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of battery used), Quantity ...
DSC - Cellular Communicator Battery Replacement
Some DSC alarm systems are using an older cellular communicator which has its' own backup battery. Eventually, this battery will wear out and have to be replaced. You will need to locate the cellular communicator.The GSM box will look something like ...
DSC Impassa - Panel Battery Replacement
Using a flat-head screwdriver, pry open the keypad by inserting the screwdriver into the two slots found on the bottom-front of your keypad. Check what battery form factor your system uses (important as they are not interchangeable): ...
DSC Wireless Keypad - Replacing Batteries
All DSC Wireless keypads use 4x AA batteries. When replacing them, we strongly recommended you use newly purchased, brand name batteries. Using off brand or no name batteries, or ones that have been sitting on a shelf or in a drawer at home) .To ...
DSC - Panel Battery Replacement
Note: Please always have your system disarmed before doing this. 1) We will need to find your security panel. (This is usually in the mechanical room or in a place discussed at the time of install). 2) After finding the security panel we will need to ...