DSC - Power G - Changing Door/Window Contact Batteries
To change the batteries on your Power G door contact, use a small flat head screw driver insert into the side slats (gently twist to open)
Use the screw driver to pop the battery out of place
The device takes CR2032 batteries which can be purchased anywhere batteries are sold . Insert new battery with writing face up and snap back into place
Replace cover, snap into place and ensure it is aligned and closed securely to avoid any tamper notifications.
You are done! If you require any further assistance please call our support desk at 306-653-3200 option 3 or email support@reedsecurity.ca
Related Articles
DSC Power Series - Key Fob Battery Change
To change the batteries on your wireless key fob, you will need a small flat head screw driver. Use the end of the screw driver to open the cover Once the cover is off, use the screw driver to remove the circuit board. Once the board has been ...
Power G Sensors - Replacement Battery Guide
Below is a chart of the various sensors used with specific DSC & Qolsys systems (predominantly DSC Neo and Qolsys IQ2+ series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of ...
DSC Wireless Keypad - Replacing Batteries
All DSC Wireless keypads use 4x AA batteries. When replacing them, we strongly recommended you use newly purchased, brand name batteries. Using off brand or no name batteries, or ones that have been sitting on a shelf or in a drawer at home) .To ...
DSC Sensors - Replacement Battery Guide
Below is a chart of the various sensors used with DSC systems (predominantly Power and Neo series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of battery used), Quantity ...
DSC - Panel Battery Replacement
Note: Please always have your system disarmed before doing this. 1) We will need to find your security panel. (This is usually in the mechanical room or in a place discussed at the time of install). 2) After finding the security panel we will need to ...