DSC Power Series - Key Fob Battery Change

To change the batteries on your wireless key fob, you will need a small flat head screw driver.

Use the end of the screw driver to open the cover

 

Once the cover is off, use the screw driver to remove the circuit board. 

Once the board has been removed, you can see where the batteries are located and need to be changed. You will need 2 CR2025 batteries.

Once the batteries have been changed, put the device back together and your task is complete! 

• Related Articles

• DSC NEO - Power G - Changing Door/Window Contact Batteries

  To change the batteries on your Power G door contact, use a small flat head screw driver insert into the side slats (gently twist to open) Use the screw driver to pop the battery out of place The device takes CR2032 batteries which can be purchased ...

• DSC Power Series Sensors - Replacement Battery Guide

  Below is a chart of the various sensors used with DSC systems (predominantly Power and Neo series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of battery used), Quantity ...

• DSC Power Series 9047 - Panel Battery Replacement

  Locate AC power and disconnect from power socket; Using a flat-head screwdriver, pry open the keypad by inserting the screwdriver into the two slots found on the bottom-front of your keypad (there may be a retention screw on the underside); ...

• DSC NEO Wireless Keypad - Replacing Batteries

  All DSC Wireless keypads use 4x AA batteries. When replacing them, we strongly recommended you use newly purchased, brand name batteries. Using off brand or no name batteries, or ones that have been sitting on a shelf or in a drawer at home) .To ...

• DSC Power Series - Managing Trouble Alerts

  Press [ * ][2] to view a trouble condition The trouble light will flash Refer to the Trouble Summary chart below to determine the trouble condition(s) present TROUBLE SUMMARY Light [1][*] Service Required - Press [1] for more information [1] Low ...