DSC NEO - PG9985 Water Sensor Battery Replacement
Replace the Battery - PowerG Wireless Water Sensor
- Insert a flat-edged screwdriver into the slot and push upward to remove the cover.
- Remove the screw and separate the cover from the base.
- Remove the old battery. Important: disposal of used batteries must be made in accordance with the waste recovery and recycling regulations in your area.
- Observing the polarity, install the new battery. Caution! Risk of explosion if battery is replaced by an incorrect type.
- Replace the cover on the base and secure with the retaining screw.
- Related Articles
- DSC NEO - PG9945 Battery Replacement- Close PG9945—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the Alarm.com Mobile App The DSC PG9945 door/window sensor requires a 3-volt ... 
- DSC NEO - PG9303 Battery Replacement- PG9303—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the alarm.com app The DSC PG9303 door/window sensor requires a 3-volt lithium ... 
- DSC NEO - PG9922—Glass Break Battery Replacement- PG9922—Battery Replacement When it is time to replace the battery in your glassbreak detector, you will see an alert on your system panel, as well as a notification in the alarm.com app The DSC PG9922 glassbreak detector requires a CR123A batteries, ... 
- DSC NEO - Power G Sensors - Replacement Battery Guide- Below is a chart of the various sensors used with specific DSC & Qolsys systems (predominantly DSC Neo and IQ2+ series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of battery ... 
- DSC NEO - PG9914 Motion Sensor Battery Replacement