DSC Wireless Keypad - Replacing Batteries

DSC Wireless Keypad - Replacing Batteries

All DSC Wireless keypads use 4x AA batteries. When replacing them, we strongly recommended you use newly purchased, brand name batteries. Using off brand or no name batteries, or ones that have been sitting on a shelf or in a drawer at home)

.To change the batteries in a DSC wireless keypad:
  1. Grasp the keypad firmly on both sides and slide it up then out from the mounting plate;
  2. Once removed, you will see the batteries inside the back of the keypad unit;
  3. Remove all batteries and replace with new batteries (see note above);
  4. Line up the holes on the back of the keypad with the tabs on the mounting plate;
  5. Place the tabs in the holes and slide down until you hear a snap (press down until you hear the 'snap'); and
  6. You may need to check and acknowledge the trouble alerts to clear the tamper alert caused by removing the keypad from the mounting plate.

If you have any questions, please contact Reed Security at 306-653-3200 or 1-844-384-SAFE (7233), option 3 for the Service/Support Desk.

    • Related Articles

    • Simon XTI - Replacing Wireless Keypad Batteries

      1. Remove back plate from touchscreen by pressing in bottom tab with screwdriver 2. Remove and replace 4 AAA Alkaline batteries, observe + / - placement   3. Route black antenna cable through back plate open slot  4. Click the touchscreen back on the ...

    • DSC-PG9303 Battery Replacement

      PG9303—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the alarm.com app The DSC PG9303 door/window sensor requires a 3-volt lithium ...

    • DSC-PG9945 Battery Replacement

      Close PG9945—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the Alarm.com Mobile App The DSC PG9945 door/window sensor requires a 3-volt ...

    • DSC - Power G Sensors - Replacement Battery Guide

      Below is a chart of the various sensors used with specific DSC & Qolsys systems (predominantly DSC Neo and Qolsys IQ2+ series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of ...

    • DSC PG9922—Glass Break Battery Replacement

      PG9922—Battery Replacement When it is time to replace the battery in your glassbreak detector, you will see an alert on your system panel, as well as a notification in the alarm.com app The DSC PG9922 glassbreak detector requires a CR123A batteries, ...