SIMON XTI- PROGRAMMING DURESS CODES
DURESS CODE DISARMS THE SYSTEM AND SENDS A SILENT ALARM TO REED SECURITY MONITORING STATION
1. Click the GEAR icon on the lower right hand side. Use the down arrow to scroll until you see PROGRAMMING
2. Press the ENTER button and enter your MASTER CODE, then press OK
3. Select ACCESS CODES and use the DOWN ARROW to scroll until you see DURESS CODE
4. Press the box beside DURESS CODE - enter new code or select the DELETE option to delete the code, then PRESS SAVE
5. Press CLOSE BUTTON twice to exit
Related Articles
Simon XTi - Managing User Codes
ADD/CHANGE USER CODES 1. Click on the GEAR icon at the bottom right then press DOWN ARROW several times 2. Press ENTER by Programming then enter your Master Code then press OK 3. Press ACCESS CODES then press the box by an empty User Code 4. Enter ...Simon XT - Managing User Codes
To change user codes on a Simon XT: Enter the System menu by pressing one of the scroll buttons or the OK button in the upper right of the panel. Scroll until the display shows System Programming, and then press OK The display will show Enter Code. ...Simon XTi - Set Time
Setting Time for a Simon XTi Panel Tap on the gear in lower corner of the screen. Tap on the down arrow to the last page. Tap the Enter button next to the top option labeled "Set Date/Time" Enter you four(4) digit MASTER CODE, tap OK button To make ...Simon XTi - Silencing Trouble Beeps
Disabling your trouble beeps should only be done when you're aware of the reason why it's beeping 1. Press the GEAR icon at the bottom righthand corner, then press the DOWN ARROW until you see Programming 2. Press ENTER by Programming and enter the ...Simon XTi - Communications Test
A communications test is used to check whether the alarm panel is communicating properly. If Comm Test is not finished, it will continue to run even if you exit program mode. To perform a local communications test (not logged by central station): ...