DSC-PG9936 Smoke Detector Battery Replacement

DSC-PG9936 Smoke Detector Battery Replacement


DSC-PG9936

Battery Installation and Replacement

CAUTION: Risk of explosion if battery is replaced with an incorrect type. Dispose of used battery according to the manufacturer's instructions.

To replace batteries, complete the following steps:

  1. Remove the detector from its mounting base by twisting the detector counterclockwise. Carefully remove batteries by lifting from the “+” end using a flathead screwdriver and dispose of them according to local regulations.
  2. To ensure a proper power-down sequence, wait a minimum of 30 seconds before installing new batteries.
  3. Install 3 new AAA batteries, available from a local Duracell or Energizer dealer, in the battery compartment. Install the batteries by inserting the “-” end first, then pushing the “+” end down. If the batteries are incorrectly inserted, please remove them carefully by lifting them out from the “+” end and correctly re-inserting them.
Qolsys Battery Compartment.jpg
  1. Re-install the detector on its mounting base by turning the detector clockwise until the + and - align.
  2. After the power-up sequence, the green LED should blink once every 60 seconds to indicate normal operation. If the batteries are not installed correctly, the detector will not operate, and the batteries may be damaged. If the detector does not power up, check that the batteries are installed correctly are fully charged.

    • Related Articles

    • Qolsys Smoke Detector- Battery Replacement

      Qolsys QS5110-840 / QS5110-P01 IQ SMOKE Smoke Heat Detector: Twist sensor counter-clockwise to remove from the base, then remove the batteries. Leave the batteries out of the sensor for a minimum of 30 seconds before installing 3 fresh AAA alkaline ...

    • DSC PG9922—Glass Break Battery Replacement

      PG9922—Battery Replacement When it is time to replace the battery in your glassbreak detector, you will see an alert on your system panel, as well as a notification in the alarm.com app The DSC PG9922 glassbreak detector requires a CR123A batteries, ...

    • DSC-PG9303 Battery Replacement

      PG9303—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the alarm.com app The DSC PG9303 door/window sensor requires a 3-volt lithium ...

    • DSC-PG9933 Carbon Monoxide Battery Replacement

      DSC-PG9933 To replace the battery: 1. Remove the detector from its mounting base by twisting it counterclockwise. Remove and dispose of the battery according to your local regulations. 2. To ensure proper power-down sequence, wait a minimum of 30 ...

    • DSC-PG9945 Battery Replacement

      Close PG9945—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the Alarm.com Mobile App The DSC PG9945 door/window sensor requires a 3-volt ...