DSC-PG9933 Carbon Monoxide Battery Replacement
DSC-PG9933
To replace the battery:
1. Remove the detector from its mounting base by twisting it counterclockwise. Remove and dispose of the battery according to your local regulations.
2. To ensure proper power-down sequence, wait a minimum of 30 seconds before
installing the new battery.
3. Install a new, 3-volt CR123A Panasonic lithium battery in the battery compartment observing correct polarity. If the battery is incorrectly inserted, remove
gently with a flathead screwdriver and correctly reinsert.
4. Reinstall the detector onto the mounting bracket by turning it clockwise.
5. After the power-up sequence, the green LED blinks once every 12 seconds to
indicate normal operation. If the battery is not installed correctly, the detector
will not operate and the battery may be damaged. 
- Related Articles
- DSC NEO - PG9303 Battery Replacement- PG9303—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the alarm.com app The DSC PG9303 door/window sensor requires a 3-volt lithium ... 
- DSC NEO - PG9945 Battery Replacement- Close PG9945—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the Alarm.com Mobile App The DSC PG9945 door/window sensor requires a 3-volt ... 
- DSC NEO - PG9922—Glass Break Battery Replacement- PG9922—Battery Replacement When it is time to replace the battery in your glassbreak detector, you will see an alert on your system panel, as well as a notification in the alarm.com app The DSC PG9922 glassbreak detector requires a CR123A batteries, ... 
- DSC NEO - Power G Sensors - Replacement Battery Guide- Below is a chart of the various sensors used with specific DSC & Qolsys systems (predominantly DSC Neo and IQ2+ series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of battery ... 
- DSC Power Series 9047 - Panel Battery Replacement- Locate AC power and disconnect from power socket; Using a flat-head screwdriver, pry open the keypad by inserting the screwdriver into the two slots found on the bottom-front of your keypad (there may be a retention screw on the underside); ...