Qolsys - Motion Detector Battery and Tamper Information

Qolsys - Motion Detector Battery and Tamper Information

How to Replace Batteries and Locate Tamper on Qolsys Motion Detector



Remove cover by depressing  the tab on the top of the motion


Replace Batteries (AAA) - notice the tamper switch (see arrows) if the cover is not connected/closed properly, the motion may go into a tamper state - you will want to ensure the cover is connected securely to avoid this. 



    • Related Articles

    • Interlogix - Changing Motion Detector Batteries

      Changing the batteries on your Simon motion detector can be a bit tricky, below are some tips/instructions on how to make it easier. Your Simon Motion will look like below To get the cover off, push the top tab and pull to release Once the cover is ...
    • Qolsys Sensors - Replacement Battery Guide

      Below is a chart of the various sensors used with Qolsys systems (predominantly IQ & IQ2 series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of battery used), Quantity ...
    • QOLSYS - Glassbreak sensor battery replacement

      Requirements 2x CR123A Lithium Batteries System must be disarmed to prevent false alarms. Instructions: Open the Device - Press the tab on the top of the device and open it. The cover should swing down. This will cause the panel to beep rapidly due ...
    • DSC - Power G Sensors - Replacement Battery Guide

      Below is a chart of the various sensors used with specific DSC & Qolsys systems (predominantly DSC Neo and Qolsys IQ2+ series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of ...
    • Qolsys IQ 2 - User Manual

      Attached is the Qolsys user manual for the IQ Panel 2.