QOLSYS Door/Window Sensor - Battery Replacement

Qolsys QS1135-840 Door/Window Sensor:

Insert a screwdriver into the slot found on the top/bottom of the cover to remove, then remove and replace 2 CR2032 batteries. When closing the sensor, ensure it is snapped together tightly and aligned properly to avoid a tamper. 

• Related Articles

• Qolsys Sensors - Replacement Battery Guide

  Below is a chart of the various sensors used with Qolsys systems (predominantly IQ & IQ2 series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of battery used), Quantity ...

• DSC NEO - Power G Sensors - Replacement Battery Guide

  Below is a chart of the various sensors used with specific DSC & Qolsys systems (predominantly DSC Neo and IQ2+ series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of battery ...

• DSC NEO - PG9303 Battery Replacement

  PG9303—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the alarm.com app The DSC PG9303 door/window sensor requires a 3-volt lithium ...

• QOLSYS - Glassbreak sensor battery replacement

  Requirements 2x CR123A Lithium Batteries System must be disarmed to prevent false alarms. Instructions: Open the Device - Press the tab on the top of the device and open it. The cover should swing down. This will cause the panel to beep rapidly due ...

• DSC NEO - PG9945 Battery Replacement

  Close PG9945—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the Alarm.com Mobile App The DSC PG9945 door/window sensor requires a 3-volt ...