DSC- WS4945 Door/Window Battery Replacements

DSC- WS4945 Door/Window Battery Replacements

To replace the battery:




    • Related Articles

    • DSC - Power G - Changing Door/Window Contact Batteries

      To change the batteries on your Power G door contact, use a small flat head screw driver insert into the side slats (gently twist to open)  Use the screw driver to pop the battery out of place The device takes CR2032 batteries which can be purchased ...
    • DSC-PG9945 Battery Replacement

      How to replace the PG9945 battery The DSC PG9945 door/window sensor requires a 3-volt lithium CR123A battery, which can be purchased at your local hardware, mass retailer, or battery store. Step-by-Step Instructions: 1. Locate the sensor with a low ...
    • DSC-PG9303 Battery Replacement

      PG9303—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the alarm.com app The DSC PG9303 door/window sensor requires a 3-volt lithium ...
    • DSC-PG9945 Battery Replacement

      Close PG9945—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the Alarm.com Mobile App The DSC PG9945 door/window sensor requires a 3-volt ...
    • QOLSYS Door/Window Sensor - Battery Replacement

      Qolsys QS1135-840 Door/Window Sensor: Insert a screwdriver into the slot found on the top/bottom of the cover to remove, then remove and replace 2 CR2032 batteries. When closing the sensor, ensure it is snapped together tightly and aligned properly ...