DSC-PG9975 Battery Replacement

DSC-PG9975 Battery Replacement

    To Replace the Batteries:


    Door and window security contact (PG9975).

    Before you start, you will need:

    • One new CR2032 Batteries (purchased online or from a local retailer)

    • 4mm flat-head screwdriver

    To replace the batteries for your Door & window security contact (PG9975), please follow the instructions below:

    1. Make sure the system is disarmed and remove the device from its original position.

    2. Insert a 4 mm flat screwdriver into the slot of the plastic cover, and flex the slot to open that side of the plastic cover.

    3. Insert the screwdriver into the slot on the other side of the plastic cover and repeat the procedure, and then remove the cover.

    4. Insert a new CR2032 lithium coin battery at an angle while observing battery polarity and then press down on the battery.

    5. Replace the cover and put the device back to its original position.

    6. After restoring a low battery trouble, the system may take up to 5 minutes to clear the trouble signal.


    • Related Articles

    • DSC-PG9303 Battery Replacement

      PG9303—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the alarm.com app The DSC PG9303 door/window sensor requires a 3-volt lithium ...
    • DSC-PG9945 Battery Replacement

      Close PG9945—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the Alarm.com Mobile App The DSC PG9945 door/window sensor requires a 3-volt ...
    • DSC-PG9945 Battery Replacement

      How to replace the PG9945 battery The DSC PG9945 door/window sensor requires a 3-volt lithium CR123A battery, which can be purchased at your local hardware, mass retailer, or battery store. Step-by-Step Instructions: 1. Locate the sensor with a low ...
    • DSC-PG9933 Carbon Monoxide Battery Replacement

      DSC-PG9933 To replace the battery: 1. Remove the detector from its mounting base by twisting it counterclockwise. Remove and dispose of the battery according to your local regulations. 2. To ensure proper power-down sequence, wait a minimum of 30 ...
    • DSC- WS4945 Door/Window Battery Replacements

      To replace the battery: