2GIG-Glass Break Sensor - How to Change Batteries
HOW TO CHANGE THE BATTERIES ON YOUR GLASS BREAK SENSOR:
YOU WILL NEED - 2 - CR123A BATTERIES
ENSURE THE SYSTEM IS DISARMED - TWIST TO REMOVE THE COVER (you may hear beeping from the system once the cover is off)
REMOVE THE CR123A BATTERIES AND REPLACE WITH FRESH BATTERIES
REPLACE THE COVER AND ENSURE IT IS CONNECTED AND ALIGNED SECURELY
If you require further assistance, please contact our support desk.
306-653-3200 option 3 or
Related Articles
DSC PG9922—Glass Break Battery Replacement
PG9922—Battery Replacement When it is time to replace the battery in your glassbreak detector, you will see an alert on your system panel, as well as a notification in the alarm.com app The DSC PG9922 glassbreak detector requires a CR123A batteries, ...QOLSYS - Glassbreak sensor battery replacement
Requirements 2x CR123A Lithium Batteries System must be disarmed to prevent false alarms. Instructions: Open the Device - Press the tab on the top of the device and open it. The cover should swing down. This will cause the panel to beep rapidly due ...General - Cleaning Sensor Battery Contacts
The battery contacts of a sensor sometimes corrode due to age or issues with the battery. Such corrosion will inhibit the battery from properly powering the sensor and it will require battery replacement more often than the other sensors. If your ...DSC Power Series - Key Fob Battery Change
To change the batteries on your wireless key fob, you will need a small flat head screw driver. Use the end of the screw driver to open the cover Once the cover is off, use the screw driver to remove the circuit board. Once the board has been ...DSC - Power G - Changing Door/Window Contact Batteries
To change the batteries on your Power G door contact, use a small flat head screw driver insert into the side slats (gently twist to open) Use the screw driver to pop the battery out of place The device takes CR2032 batteries which can be purchased ...