Communications
DSC Maxsys - System/Communications Test
This option will test the system. This bell/siren will activate for two seconds and system will send a test code transmission to the monitoring station. To start the System test, perform the following: Press [*] [6], then enter a valid access code ...
DSC Power Series - Non-alpha (Icon) Keypad system test
Here are step-by-step instructions on how to perform a system/communications test of your alarm system (DSC Power Series or DSC Power Series Neo) Security Alarm Monitoring System, and how to silence that beep: Call Reed Security Support (306-653-3200 ...
DSC - Communications Failure Troubleshooting
If your DSC alarm system is not communicating with the monitoring station, this is often due to some issue with the communications line (landline or cellular communicator). Often repair work or services changes have been made to the landline which ...
DSC - Alpha Keypad communication test
An alpha keypad has words in the vertical column of keys of the right hand side of the keypad. Note: * If siren is on site, Doing a communication test will cause the siren to go off for 2 sec. * Always call the monitoring station before ...
DSC - Non-alpha Keypad communications test
An non-alpha keypad has icons/images in the vertical column of keys of the right hand side of the keypad. Note: * If siren is on site, Doing a communication test will cause the siren to go off for 2 sec. * Always call the monitoring station ...