DSC Maxsys - System/Communications Test

DSC Maxsys - System/Communications Test

This option will test the system. This bell/siren will activate for two seconds and system will send a test code transmission to the monitoring station. To start the System test, perform the following:
  1. Press [*] [6], then enter a valid access code which has the “System Master” or “Supervisor” option enabled.
  2. Press [1] to enter the Function menu
  3. Press [0] to enter "System Test"
  4. When the test is finished, press [#] to exit.
Contact Reed Security support at 306-653-3200 or  the monitoring station at 1-800-268-6870 to confirm if the communications test was successful.

    • Related Articles

    • DSC Alexor - System Test

      Here are step-by-step instructions on how to perform a system/communications test of your alarm system (DSC Alexor) Security Alarm Monitoring System, and how to silence that beep: Call Reed Security Support (306-653-3200 option 3) or your Monitoring ...

    • DSC - Communications Failure Troubleshooting

      If your DSC alarm system is not communicating with the monitoring station, this is often due to some issue with the communications line (landline or cellular communicator). Often repair work or services changes have been made to the landline which ...

    • Simon XTi - Communications Test

      A communications test is used to check whether the alarm panel is communicating properly. If Comm Test is not finished, it will continue to run even if you exit program mode. To perform a local communications test (not logged by central station): ...

    • DSC Power Series - Non-alpha (Icon) Keypad system test

      Here are step-by-step instructions on how to perform a system/communications test of your alarm system (DSC Power Series or DSC Power Series Neo) Security Alarm Monitoring System, and how to silence that beep: Call Reed Security Support (306-653-3200 ...

    • DSC Maxsys - Bypassing Zones

      On an Maxsys system, the Bypass Zone feature may be used to troubled zone so the system can be armed. To use this feature: Press [*][1] Enter your master code Press [1] for Bypass Zone option Use the arrow keys, [<][>], to scroll through the zones to ...