GE/Interlogix Simon XTi - How to Clear Troubles/Alerts
1. Press the Gear icon in the bottom right-hand corner of the screen (if there is a yellow triangle next to it, there are uncleared messages).
2. Press Listen (labelled Hear in the image below) to listen to the trouble messages and alerts (if there is a yellow triangle next to it, there are uncleared messages). Wait for all messages to finish.
3. Press Clear.
4. Repeat steps 2 & 3 until all messages are cleared. If a message does not clear, it is an active issue.
You should always end with pressing Listen.
5. Press Close.
Related Articles
GE/Interlogix Simon XTi - User Guide
See attachedGE/Interlogix Simon XT - Troubleshooting Trouble Beeps and Messages
Your security system is able to automatically test itself for: Power failures Low batteries Communication troubles with sensors Communication troubles with the central monitoring station When your security system detects one of the problems above, ...GE/Interlogix Simon XTi - Silencing Trouble Beeps
Disabling your trouble beeps should only be done when you're aware of the reason why it's beeping 1. Press the GEAR icon at the bottom righthand corner, then press the DOWN ARROW until you see Programming 2. Press ENTER by Programming and enter the ...DSC Power Series - Managing Trouble Alerts
Press [ * ][2] to view a trouble condition The trouble light will flash Refer to the Trouble Summary chart below to determine the trouble condition(s) present TROUBLE SUMMARY Light [1][*] Service Required - Press [1] for more information [1] Low ...DSC Maxsys - Managing Trouble Alerts
On an Maxsys system, the Trouble Acknowledgement feature may be used to acknowledge and clear old troubles. To use this feature: Press [*][2] Use the arrow keys, [<][>], to scroll through the list of trouble conditions If you have any questions about ...