GE/Interlogix Simon XT - Acknowledging Status Messages

GE/Interlogix Simon XT - Acknowledging Status Messages

Some types of status conditions, such as alarm history, must be cleared manually. To clear system status, press Status, read and/or listen to the status messages, and then press Disarm. If the trouble condition was a low system battery, perform a sensor test. The Status light should turn off if all trouble conditions have been corrected. If the light does not clear or reappears shortly afterwards, the issue is still ongoing and may require servicing.

    • Related Articles

    • GE/Interlogix Simon XT - Managing User Codes

      To change user codes on a Simon XT: Enter the System menu by pressing one of the scroll buttons or the OK button in the upper right of the panel. Scroll until the display shows System Programming, and then press OK The display will show Enter Code. ...

    • GE/Interlogix Simon XT - Troubleshooting Trouble Beeps and Messages

      Your security system is able to automatically test itself for: Power failures Low batteries Communication troubles with sensors Communication troubles with the central monitoring station When your security system detects one of the problems above, ...

    • GE/Interlogix Simon XT - Power down

      1) Find your alarms Transformer ( plug in adapter) Usually in the mechanical room or in a designated place you and your reed security installer talked about. 2) Go to your keypad and press down on the two tabs on the top of the keypad. This will ...

    • GE/Interlogix Simon XTi - User Guide

      See attached

    • GE/Interlogix Simon 3 - Adjusting Status Sound Volume

      It is possible to adjust the volume of the Status Sound on your Simon 3 alarm panel, such as arming beeps, trouble beeps, and status beeps. The lowest volume setting is 1, the highest is 10. If you are turning down the volume of trouble beeps during ...