Simon XT - Communications Test

Simon XT - Communications Test

Test communications between your system and the central monitoring station at least once a week to make sure you have the proper telephone connection.
To test communications with the monitoring station with your system, follow the instructions below:
The system must be in disarm mode.
Use the arrow keys [<][>] to scroll until the display shows 'System Tests', and then press OK. The display will show 'Enter Code'.
Enter your master code, and then press OK. The display shows 'Comm Test'.
Press OK. The display shows 'Comm Test is On'.
If the communication test is successful, the display shows 'Comm Test OK'.
Press Status repeatedly to exit.
If the communication test is successful, the display shows Comm Test OK. If the test is unsuccessful, the Status button will light within 10 minutes and the display shows Comm Failure. If a communication test fails, call your security dealer
If you have any questions, contact Reed Security Support Desk at 306-653-3200 or 1.844.384.SAFE (7233) then option 3 to reach the support desk.

    • Related Articles

    • Simon XTi - Communications Test

      A communications test is used to check whether the alarm panel is communicating properly. If Comm Test is not finished, it will continue to run even if you exit program mode. To perform a local communications test (not logged by central station): ...

    • DSC Maxsys - System/Communications Test

      This option will test the system. This bell/siren will activate for two seconds and system will send a test code transmission to the monitoring station. To start the System test, perform the following: Press [*] [6], then enter a valid access code ...

    • Simon XT - Power down

      1) Find your alarms Transformer ( plug in adapter) Usually in the mechanical room or in a designated place you and your reed security installer talked about. 2) Go to your keypad and press down on the two tabs on the top of the keypad. This will ...

    • Simon XT - Managing User Codes

      To change user codes on a Simon XT: Enter the System menu by pressing one of the scroll buttons or the OK button in the upper right of the panel. Scroll until the display shows System Programming, and then press OK The display will show Enter Code. ...

    • DSC Alexor - System Test

      Here are step-by-step instructions on how to perform a system/communications test of your alarm system (DSC Alexor) Security Alarm Monitoring System, and how to silence that beep: Call Reed Security Support (306-653-3200 option 3) or your Monitoring ...