Simon XT - Acknowledging Status Messages
Some types of status conditions, such as alarm history, must be cleared manually. To clear system status, press Status, read and/or listen to the status messages, and then press Disarm. If the trouble condition was a low system battery, perform a sensor test. The Status light should turn off if all trouble conditions have been corrected. If the light does not clear or reappears shortly afterwards, the issue is still ongoing and may require servicing.
Related Articles
Simon XT - Managing User Codes
To change user codes on a Simon XT: Enter the System menu by pressing one of the scroll buttons or the OK button in the upper right of the panel. Scroll until the display shows System Programming, and then press OK The display will show Enter Code. ...
Simon XT- Turning off Trouble Beeps
To turn off the trouble beeps at your key pad: Scroll down on the Simon XT until you see "System Programming" Immediately press "OK" Enter your Master Code and press "OK" It will display "Access Codes" Scroll down until you see "Siren Options" Press ...
Simon XT - Power down
1) Find your alarms Transformer ( plug in adapter) Usually in the mechanical room or in a designated place you and your reed security installer talked about. 2) Go to your keypad and press down on the two tabs on the top of the keypad. This will ...
Simon XT - How to Reset the Clock.
Scroll up/down until the display shows Set Clock. Press OK. The display shows Enter Code. Enter your master code with numeric keys. Press OK. Press OK again. The display now flashes the hours. Scroll up/down to set the hours. Press the OK key to ...
Simon XT - Turning the keypad beeps off.
1 Press the down arrow 5 times and you will see "System Programming" 2 Press OK followed by your master disarm code. 3 Press OK 4 Press the down arrow 4 times and you will see " Siren Options" 5 Press OK 6 You will see " Piezo Beeps" Press OK 7 Press ...