DSC - Non-alpha Keypad, Set Time/Date
1) Press * followed by 6.
2) Enter in your master access code. (the code you use to disarm the system)
Please note the master code is the only code that can make changes, A user code will not be able to make changes.
3) Press 1
4) Enter in the Hour, minute, Month, Day, Year. Ex: 0930051515 for 9:30 AM May 15th, 2015
Please note that the time needs to be programmed as a 24hr clock and enter two digits for each value.
Example for Dec 28th 1988 (12/28/88)
5) After you have entered in the time and date press the # button 3 times and that will get you to the main screen.
***!!!***You have entered the time and date on your Keypad***!!!***
Related Articles
DSC - Alpha Keypad, Set Time/Date
1) Press * followed by 6. 2) You will be asked to enter in your master access code. (the code you use to disarm the system) Please note the master code is the only code that can make changes, A user code will not be able to make changes. 3) Press the ...
DSC - Communications Failure Troubleshooting
If your DSC alarm system is not communicating with the monitoring station, this is often due to some issue with the communications line (landline or cellular communicator). Often repair work or services changes have been made to the landline which ...
DSC - Non-alpha keypad, Control other partitions from one keypad (Partition Jumping)
Note: This will work with the PC1616/PC1832/PC1864 Non Alpha keypad's 1) Using your Keypad press and hold the # button for 3 sec. Note: Partitions will have to be enabled by your installer and should of been talked about before the install. 2) ...
DSC - Reboot/Power Cycle
Note: Please always have your system disarmed before doing this. 1) We will need to find your security panel (This is usually in the mechanical room or in a place discussed at the time of install). 2) After finding the security panel we will need to ...
DSC - Panel Battery Replacement
Note: Please always have your system disarmed before doing this. 1) We will need to find your security panel. (This is usually in the mechanical room or in a place discussed at the time of install). 2) After finding the security panel we will need to ...