Simon XTI - Replacing Wireless Keypad Batteries

Simon XTI - Replacing Wireless Keypad Batteries

1. Remove back plate from touchscreen by pressing in bottom tab with screwdriver

44.JPG

2. Remove and replace 4 AAA Alkaline batteries, observe + / - placement

 55.JPG

3. Route black antenna cable through back plate open slot 

back_plate.JPG

4. Click the touchscreen back on the back plate to finish

 presure.JPG

You are done!  If you have questions - please reach out to the support desk at 306-653-3200 option 3 or support@reedsecurity.ca 

    • Related Articles

    • DSC Wireless Keypad - Replacing Batteries

      All DSC Wireless keypads use 4x AA batteries. When replacing them, we strongly recommended you use newly purchased, brand name batteries. Using off brand or no name batteries, or ones that have been sitting on a shelf or in a drawer at home) .To ...
    • Simon XT - Replacing Panel Battery

      REPLACING YOUR SIMON XT BATTERY 1) Go to your keypad and press down on the two tabs on the top of the keypad. This will allow for the front of the keypad to swing down.  Some keypads have a screw at the top between the two tabs that may need to be ...
    • SIMON XTI - Replacing Panel Battery

    • Interlogix - Changing Motion Detector Batteries

      Changing the batteries on your Simon motion detector can be a bit tricky, below are some tips/instructions on how to make it easier. Your Simon Motion will look like below To get the cover off, push the top tab and pull to release Once the cover is ...
    • Interlogix Sensors - Replacement Battery Guide

      Below is a chart of the various sensors used with GE/ITI systems (predominantly Simon series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of battery used), Quantity (needed), ...