Simon XTi-Power Cycle/Power Down Panel
HOW TO POWER CYCLE THE PANEL
- Insert a coin into the bottom right corner slot, then twist to remove the front faceplate.
- Pry the top two tabs up, then fold down front cover.
- Unplug the battery pack
4. Disconnect the AC transformer, then wait approximately 2 minutes
5. Reconnect the battery, then the AC transformer
(The panel should complete within 5 minutes)
HOW TO POWER DOWN THE PANEL
1. repeat steps 1-5 as per above but DO NOT reconnect the battery or AC transformer
Related Articles
Simon XTi - Reboot/Power Cycle
If your Simon XTi has stopped responding, often a quick restart or reboot may resolve the issue. The following is a simple procedure that take about 5 minutes to complete: Carefully pull the trim ring (B) off the edges of your panel. (Use notch, C, ...Qolsys IQ2 - Reboot/Power Cycle
Complete the following steps to reboot your Qolsys IQ Panel 2 using the standard method: Access advanced settings. Start from the main screen of your IQ Panel 2. Press the small grey bar at the top of the screen. Choose Settings, followed by Advanced ...DSC - Reboot/Power Cycle
Note: Please always have your system disarmed before doing this. 1) We will need to find your security panel (This is usually in the mechanical room or in a place discussed at the time of install). 2) After finding the security panel we will need to ...IQ4/IQ2 - Panel Reboot
HOW DO I REBOOT QOLSYS IQ4 PANEL A reboot acts as a quick and effective solution if you’re having issues with your electronic devices. The Qolsys IQ4 panel is no exemption in that case. The panel can encounter issues like glitches, temporary software ...Simon XTi - Communications Test
A communications test is used to check whether the alarm panel is communicating properly. If Comm Test is not finished, it will continue to run even if you exit program mode. To perform a local communications test (not logged by central station): ...