GE/Interlogix Simon XT - Communications Test

GE/Interlogix Simon XT - Communications Test

Alert
Test communications between your system and the central monitoring station at least once a week to make sure you have the proper telephone connection.
To test communications with the monitoring station with your system, follow the instructions below:
Notes
The system must be in disarm mode.
Use the arrow keys [<][>] to scroll until the display shows 'System Tests', and then press OK. The display will show 'Enter Code'.
Enter your master code, and then press OK. The display shows 'Comm Test'.
Press OK. The display shows 'Comm Test is On'.
If the communication test is successful, the display shows 'Comm Test OK'.
Press Status repeatedly to exit.
Notes
If the communication test is successful, the display shows Comm Test OK. If the test is unsuccessful, the Status button will light within 10 minutes and the display shows Comm Failure. If a communication test fails, call your security dealer
If you have any questions, contact Reed Security Support Desk at 306-653-3200 or 1.844.384.SAFE (7233) then option 3 to reach the support desk.

    • Related Articles

    • GE/Interlogix Simon XTi - User Guide

      See attached

    • GE/Interlogix Simon XTi - Communications Test

      A communications test is used to check whether the alarm panel is communicating properly. If Comm Test is not finished, it will continue to run even if you exit program mode. To perform a local communications test (not logged by central station): ...

    • GE/Interlogix Simon XT - Managing User Codes

      To change user codes on a Simon XT: Enter the System menu by pressing one of the scroll buttons or the OK button in the upper right of the panel. Scroll until the display shows System Programming, and then press OK The display will show Enter Code. ...

    • GE/Interlogix Simon XT - Power down

      1) Find your alarms Transformer ( plug in adapter) Usually in the mechanical room or in a designated place you and your reed security installer talked about. 2) Go to your keypad and press down on the two tabs on the top of the keypad. This will ...

    • GE/Interlogix Simon XT - Replacing Panel Battery

      REPLACING YOUR SIMON XT BATTERY 1) Go to your keypad and press down on the two tabs on the top of the keypad. This will allow for the front of the keypad to swing down. Some keypads have a screw at the top between the two tabs that may need to be ...