GE/Interlogix Simon XT - How to Reset the Clock.

GE/Interlogix Simon XT - How to Reset the Clock.

  1. Scroll up/down until the display shows Set Clock.
  2. Press OK.
  3. The display shows Enter Code.
  4. Enter your master code with numeric keys. Press OK.
  5. Press OK again. The display now flashes the hours.
  6. Scroll up/down to set the hours.
  7. Press the OK key to accept. The display now flashes the minutes.
  8. Scroll up/down to set the minutes.
  9. Press the OK key to accept. The display is now flashing the AM/PM.
  10. Scroll up/down to set the AM/PM.
  11. Press OK to accept. The display now shows the current time, and stops flashing.
  12. Press STATUS twice to exit.

    • Related Articles

    • GE/Interlogix Simon XTi - User Guide

      See attached

    • GE/Interlogix Simon XT - Managing User Codes

      To change user codes on a Simon XT: Enter the System menu by pressing one of the scroll buttons or the OK button in the upper right of the panel. Scroll until the display shows System Programming, and then press OK The display will show Enter Code. ...

    • GE/Interlogix Simon XT - Power down

      1) Find your alarms Transformer ( plug in adapter) Usually in the mechanical room or in a designated place you and your reed security installer talked about. 2) Go to your keypad and press down on the two tabs on the top of the keypad. This will ...

    • GE/Interlogix Simon XT - Replacing Panel Battery

      REPLACING YOUR SIMON XT BATTERY 1) Go to your keypad and press down on the two tabs on the top of the keypad. This will allow for the front of the keypad to swing down. Some keypads have a screw at the top between the two tabs that may need to be ...

    • GE/Interlogix Simon XT - Troubleshooting Trouble Beeps and Messages

      Your security system is able to automatically test itself for: Power failures Low batteries Communication troubles with sensors Communication troubles with the central monitoring station When your security system detects one of the problems above, ...