Qolsys - Water Sensor

Find below an example of an installed Qolsys water sensor. The lower section is the actual water sensor while the upper section is the battery/transmitter. Click the image to see a larger version of the image.

• Related Articles

• DSC-PG9985 Water Sensor Battery Replacement

  Replace the Battery - PowerG Wireless Water Sensor Insert a flat-edged screwdriver into the slot and push upward to remove the cover. Remove the screw and separate the cover from the base. Remove the old battery. Important: disposal of used batteries ...

• General - Cleaning Sensor Battery Contacts

  The battery contacts of a sensor sometimes corrode due to age or issues with the battery. Such corrosion will inhibit the battery from properly powering the sensor and it will require battery replacement more often than the other sensors. If your ...

• Qolsys Sensors - Replacement Battery Guide

  Below is a chart of the various sensors used with Qolsys systems (predominantly IQ & IQ2 series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of battery used), Quantity ...

• Qolsys IQ 2 - User Manual

  Attached is the Qolsys user manual for the IQ Panel 2.

• QOLSYS - Glassbreak sensor battery replacement

  Requirements 2x CR123A Lithium Batteries System must be disarmed to prevent false alarms. Instructions: Open the Device - Press the tab on the top of the device and open it. The cover should swing down. This will cause the panel to beep rapidly due ...