Qolsys IQ2 - Battery Replacement

Swipe down from time display to open a drop-down box then press  SETTINGS.

 

Press Advanced Settings, then enter your Master Code

 

Press Power Down then press OK to confirm, the IQ Panel 2 will turn off.

 

Remove the bottom screen then press both bottom tabs to remove the front face-plate. 

Rotate the front cover down and hang the strap onto the back plate. 

Unplug the battery connector from the circuit board then pull the blue tab from under the battery outward to remove. 
Remove adhesive film protector from the new battery and stick it into the case. Plug the battery connector back into the board and close the cover.

Press the button on right side edge for 3 to 4 seconds to power up system.

• Related Articles

• Qolsys IQ - Battery replacement

  Power Down As per Qolsys IQ - Reboot/Power Down Replace Battery

• Qolsys IQ - Battery Replacement

  Qolsys IQ Panel – Battery Replacement Guide To replace the battery in your IQ panel, we'll need to power the panel down. 1. Select "Settings"  2. Enter your "Master Code" 3. Select "Power Down" 4. Select "OK" 5. Before continuing, wait till the ...

• Qolsys Sensors - Replacement Battery Guide

  Below is a chart of the various sensors used with Qolsys systems (predominantly IQ & IQ2 series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of battery used), Quantity ...

• QOLSYS - Glassbreak sensor battery replacement

  Requirements 2x CR123A Lithium Batteries System must be disarmed to prevent false alarms. Instructions: Open the Device - Press the tab on the top of the device and open it. The cover should swing down. This will cause the panel to beep rapidly due ...

• Qolsys IQ 2 - User Manual

  Attached is the Qolsys user manual for the IQ Panel 2.