Simon XTi - Reboot/Power Cycle

Simon XTi - Reboot/Power Cycle

If your Simon XTi has stopped responding, often a quick restart or reboot may resolve the issue. The following is a simple procedure that take about 5 minutes to complete:
  1. Carefully pull the trim ring (B) off the edges of your panel. (Use notch, C, in lower right to start trim removal)
  2. Press and immediately release the 'Reset Button' on the left side (Button D, on lower left) **DO NOT HOLD BUTTON (see warning at bottom)**
  3. Place the trim ring back on your system

DO NOT HOLD DOWN RESET BUTTON. JUST PRESS AND IMMEDIATELY RELEASE. 
Holding down the button may reset all settings to factory default and will require a billable onsite service visit to reprogram your system
.
 

    • Related Articles

    • Simon XTi-Power Cycle/Power Down Panel

      HOW TO POWER CYCLE THE PANEL Insert a coin into the bottom right corner slot, then twist to remove the front faceplate. Pry the top two tabs up, then fold down front cover. Unplug the battery pack 4. Disconnect the AC transformer, then wait ...

    • Qolsys IQ2 - Reboot/Power Cycle

      Complete the following steps to reboot your Qolsys IQ Panel 2 using the standard method: Access advanced settings. Start from the main screen of your IQ Panel 2. Press the small grey bar at the top of the screen. Choose Settings, followed by Advanced ...

    • DSC - Reboot/Power Cycle

      Note: Please always have your system disarmed before doing this. 1) We will need to find your security panel (This is usually in the mechanical room or in a place discussed at the time of install). 2) After finding the security panel we will need to ...

    • Simon XTi - Set Time

      Setting Time for a Simon XTi Panel Tap on the gear in lower corner of the screen. Tap on the down arrow to the last page. Tap the Enter button next to the top option labeled "Set Date/Time" Enter you four(4) digit MASTER CODE, tap OK button To make ...

    • Qolsys IQ - Panel Unresponsive

      It is rare for the panel to freeze up and not respond, but if this happens, you'll need to reboot the system. If your system is DISARMED and it freezes, press and hold the Home button for 60 seconds.  If the screen is displaying something, the screen ...