SIMON XTI - Replacing Panel Battery

SIMON XTI - Replacing Panel Battery








    • Related Articles

    • Simon XT - Replacing Panel Battery

      REPLACING YOUR SIMON XT BATTERY 1) Go to your keypad and press down on the two tabs on the top of the keypad. This will allow for the front of the keypad to swing down.  Some keypads have a screw at the top between the two tabs that may need to be ...
    • Simon XTI - Replacing Wireless Keypad Batteries

      1. Remove back plate from touchscreen by pressing in bottom tab with screwdriver 2. Remove and replace 4 AAA Alkaline batteries, observe + / - placement   3. Route black antenna cable through back plate open slot  4. Click the touchscreen back on the ...
    • DSC Alexor - Panel Battery Replacement

      Security system backup batteries are necessary for the proper operation of the system during a power outage. If the system reports the backup battery has low charge, it will not be able to support the system as long as it could with a full charge. If ...
    • Simon XTi-Power Cycle/Power Down Panel

      HOW TO POWER CYCLE THE PANEL Insert a coin into the bottom right corner slot, then twist to remove the front faceplate. Pry the top two tabs up, then fold down front cover. Unplug the battery pack 4. Disconnect the AC transformer, then wait ...
    • DSC - Panel Battery Replacement-NO POWER DOWN

      Note: Please always have your system disarmed before doing this. 1) Find your security panel. (This is usually in the mechanical room or in a place discussed at the time of install). 2) After finding the security panel, we will need to open it and ...