DSC - Alpha Keypad, Set Time/Date
1) Press * followed by 6.
2) You will be asked to enter in your master access code. (the code you use to disarm the system)
Please note the master code is the only code that can make changes, A user code will not be able to make changes.
3) Press the right arrow 2 times. You will see the option Time and Date.
4) press * to get you into the time and date programming.
5) Enter in the Hour, minute, Month, Day, Year. Ex: 0930051515 for 9:30 AM May 15th, 2015
Please note that the time needs to be programmed as a 24hr clock and all values are 2 digits each.
Example for Dec 28th 1988 (12/28/88)
6) After you have entered in the time and date press the # button 3 times and that will get you to the main screen.
***!!!***You have entered the time and date on your Keypad***!!!***
Related Articles
DSC - Non-alpha Keypad, Set Time/Date
1) Press * followed by 6. 2) Enter in your master access code. (the code you use to disarm the system) Please note the master code is the only code that can make changes, A user code will not be able to make changes. 3) Press 1 4) Enter in the Hour, ...Simon XTi - Set Time
Setting Time for a Simon XTi Panel Tap on the gear in lower corner of the screen. Tap on the down arrow to the last page. Tap the Enter button next to the top option labeled "Set Date/Time" Enter you four(4) digit MASTER CODE, tap OK button To make ...DSC - Non-alpha keypad, Control other partitions from one keypad (Partition Jumping)
Note: This will work with the PC1616/PC1832/PC1864 Non Alpha keypad's 1) Using your Keypad press and hold the # button for 3 sec. Note: Partitions will have to be enabled by your installer and should of been talked about before the install. 2) ...DSC - Alpha Keypad communication test
An alpha keypad has words in the vertical column of keys of the right hand side of the keypad. Note: * If siren is on site, Doing a communication test will cause the siren to go off for 2 sec. * Always call the monitoring station before ...DSC - Alpha keypad, Manage user codes
Please Note that user code 40 is your master code For a PC 1616 you have 1-48 user slots For a PC 1832 you have 1-72 user slots For a PC 1864 you have 1-95 user slots 1) From your keypad press * followed by 5. 2) Enter in your master code. (Disarm ...