DSC-PG9945 Battery Replacement

DSC-PG9945 Battery Replacement

How to replace the PG9945 battery

The DSC PG9945 door/window sensor requires a 3-volt lithium CR123A battery, which can be purchased at your local hardware, mass retailer, or battery store.

Step-by-Step Instructions:

1. Locate the sensor with a low battery 

2. Insert a flat-edged screwdriver into the slot and push upward to remove the cover, then remove the screw and separate the cover from the base.


3. Remove and replace the 3-volt lithium CR123A battery.


4. Make sure the area where the batteries are stored is clean and there is no corrosion.

5. Put the cover back on starting with the opposite end from which it was opened, returning the screw then the outer cover. You should hear a snapping sound if it closes correctly.

6. Check if the low battery status has cleared 

 

    • Related Articles

    • DSC-PG9303 Battery Replacement

      PG9303—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the alarm.com app The DSC PG9303 door/window sensor requires a 3-volt lithium ...

    • DSC-PG9945 Battery Replacement

      Close PG9945—Battery Replacement When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel, as well as a notification in the Alarm.com Mobile App The DSC PG9945 door/window sensor requires a 3-volt ...

    • DSC - Power G - Changing Door/Window Contact Batteries

      To change the batteries on your Power G door contact, use a small flat head screw driver insert into the side slats (gently twist to open)  Use the screw driver to pop the battery out of place The device takes CR2032 batteries which can be purchased ...

    • DSC- WS4945 Door/Window Battery Replacements

      To replace the battery:

    • DSC - Power G Sensors - Replacement Battery Guide

      Below is a chart of the various sensors used with specific DSC & Qolsys systems (predominantly DSC Neo and Qolsys IQ2+ series alarm systems). Included is the Sensor Type (primary use), Part #/Description (mostly used by dealers), Voltage, Type (of ...