DSC Impassa - Volume Control
DSC systems refer to their built-in sounder as the "buzzer". The DSC Impassa has 21 different buzzer volume levels that can be used. Setting the system to the lowest level will mute the keypad entirely. The volume for the system can be changed at any time. You will required the system Master Code to access the volume settings menu.
How to adjust the DSC Impassa buzzer level:
- Access volume settings: From the system's home screen, press [*] [6] [Master Code]. Afterwards, press the left arrow [<] once to reach "Buzzer Control". Then press the [*] key. You should have access to the volume settings menu.
- Adjust the volume: Use the left and right arrows on the system to change the volume. Pressing the left arrow [<] will decrease the volume one level. Pressing the right arrow [>] will increase the volume one level. Continue until the desired volume level is set. Remember, there are 21 different possible volume levels that can be used with the DSC Impassa System. Adjusting the volume to the lowest possible setting will mute the system entirely. Trying to set the volume any lower than this will have no effect. Likewise, trying to increase the volume beyond the maximum setting of 21 will not work either.
- Save the changes. Press the [#] to exit the volume settings menu. The new volume will be set with the system.
Related Articles
DSC - Adjust the volume on Power Series and NEO keypads
It is possible to adjust the volume level on DSC Power Series and NEO keypads. For Alpha keypads (buttons on the right-hand edge are words): Press [*] and then the [6] button on the keypad Enter your master Code Use the [<] Key to scroll through ...
DSC Impassa - Panel Battery Replacement
Using a flat-head screwdriver, pry open the keypad by inserting the screwdriver into the two slots found on the bottom-front of your keypad. Check what battery form factor your system uses (important as they are not interchangeable): ...
DSC Impassa - Managing Trouble Alerts
On an Impassa system, the Trouble Acknowledgement feature may be used to acknowledge and clear old troubles and possibly override existing troubles, so the system can be armed. To use this feature: Press [*][2] to enter the Trouble menu. Scroll left ...
DSC Alexor - System Test
Here are step-by-step instructions on how to perform a system/communications test of your alarm system (DSC Alexor) Security Alarm Monitoring System, and how to silence that beep: Call Reed Security Support (306-653-3200 option 3) or your Monitoring ...
Qolsys IQ2 - Adjusting Volume
Access the Sounds Menu. Start from the home screen of the system. Press the small grey bar at the top of the screen. Choose Settings, followed by Advanced Settings. Then enter your Master Code. Then choose Sound. This will take you into the Sound ...