Alarm.com - Reboot or factory reset a SkyBell Doorbell Camera

Alarm.com - Reboot or factory reset a SkyBell Doorbell Camera

Reboot or factory reset a SkyBell Doorbell Camera

The SkyBell Doorbell Camera can be rebooted locally using the doorbell's button.

Option one: Doorbell Button reboot
  1. Press and hold the [Skybell] button (face of device) for approximately 50 seconds.
  2. Release after the button starts flashing blue.

SkyBell HD Wi-Fi Doorbell Camera (ADC-VDB101/102):

SkyBell_hd_blueflashing.gif

Slim Line Wi-Fi Doorbell Camera (ADC-VDB105/106):

SkyBell_slim_powercycle_blueflashing.gif

Option two: Pinhole button reboot

Note: Only the Slim Line Wi-Fi Doorbell Camera (ADC-VDB105/106) has a pinhole reboot button.

  1. Using a paper clip or something similar, press and hold the pinhole button (located on bottom of device).
  2. Release after 30 seconds.
  1. Using a paper clip or something similar, press and hold the pinhole button.
  2. Release after 30 seconds.
SkyBell_slim_power_cycle_v3.gif

Factory reset a SkyBell Doorbell Camera

Caution: This action deletes all Wi-Fi and configuration information from the device.

  1. Press and hold the [Skybell] button for approximately 80 seconds.
  2. Release after the button starts flashing yellow. The Doorbell Camera then reboots and reverts to AP mode (i.e., flashing red and green LED).

SkyBell HD Wi-Fi Doorbell Camera (ADC-VDB101/102):

Skybell_Reset_Yellow.png

Slim Line Wi-Fi Doorbell Camera (ADC-VDB105/106):

SkyBell_Slim_Reset_Yellow.png

For more information about the different LED colors and what they mean, see What do the LEDs on my SkyBell Doorbell Camera mean?.